Oven Light; Troubleshooting - Whirlpool WFE715H0ES User Instructions

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty page in this manual and scan the code there with your mobile device, or visit http://www.whirlpool.com/product_help.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Oven will not operate
Convection fan not working
Oven temperature too high or
too low
Oven indicator lights flash
Display shows messages
16

Oven Light

TROUBLESHOOTING

POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
Range is in Sabbath Mode.
The control knob is set
incorrectly.
The range is in Demo Mode.
Cookware that is not the proper
size.
Control knob set to incorrect heat
level.
Range is not level.
The electronic oven control was
set incorrectly.
Delay Start was set.
The oven control lockout is set.
The range is in Demo Mode.
Oven door is open.
Oven temperature calibration
needs adjustment.
Temperature has been changed
to Fahrenheit or Celsius.
Needs service (oven indicator
lights are flashing).
Power failure (display shows
flashing time).
Error code (display shows letter
followed by number).
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See "Sabbath Mode" section.
Push in knob before turning to a setting.
Demo Mode will deactivate the Warm Zone element. See
"Demo Mode" in the "Electronic Oven Controls" section.
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
See "Cooktop Use" section.
Level the range. See the Installation Instructions.
See "Electronic Oven Controls" section.
See "Cook Time" section.
See the control lock keypad feature in the "Feature Guide"
section.
Demo Mode will deactivate all heating elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
Close oven door. See "Convection Cooking" section.
See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Fahrenheit and Celsius" in the "Electronic Oven Controls"
section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator light(s) keeps flashing, call for service.
See cover for contact information.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Press the CANCEL keypad to clear the display. See "Control
Display" in the "Electronic Oven Controls" section. If it
reappears, call for service. See cover for contact information.