Table of Contents
Advertisement
3
Faults and what to do
about them
E mergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m
E.g. power outage or in the event of a
loss of power
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the appliance door can be
opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
Information on the display panel
Fault code
‹˜"¯
"‚
"†
"‡ ˜—¯˜
—Ÿ –©'š
•‚ "Ÿš
–‹ "Ÿš
Other fault codes are only for use by the after-sales service. Make a note of the fault code to inform the
after sales service.
The door is not properly closed. Close the door.
The water control system has been activated. Disconnect the appliance from the
mains, turn off the tap and advise the after-sales service.
Water is not entering the appliance. See the fault Water is not flowing in
The water is not Drained. See the fault Water is not Drained
Not a fault! The unbalanced load detection system has detected an unbalanced
load caused by laundry items. The fluff removal cycle cannot start. Remove the
laundry.
Maximum or minimum drying load not taken into account. HI/End or LO/End
flash alternately in the display. See information for the Drying result not satisfac-
tory fault..
Faults and what to do about them
Caution!
Risk when reaching into/gripping the
rotating drum!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
Switch off the appliance. Pull out the
1.
mains plug.
Drain the water ~ Page 43
2.
Pull the emergency release
3.
downwards with a tool and open the
door on the same time.
en
45
Advertisement
Table of Contents
