Table of Contents
Advertisement
Network Setup
Network Setup
System Setup
HDCP ON / OFF
English
1. Press "ENTER" or → to Format select and from
bottom menu select the format type. (Default: H.264)
2. Recording format selection:
● AVI
● Webcam: Data stream is H.264 format but emulating
RJ45 Webcam; use for connecting external PC.
● H.264
3. DHCP: Enable or disable DHCP.
The default IP address is 192.168.0.200
The default Subnet: 255.255.255.0
Manual IP setting is enabled when DHCP is turned on.
4. Manual IP Setup for LAN video streaming.
5. Adjust the audio fader for audio level (Default: 75%);
press speaker icon to mute the audio output.
Mute
●
1. Press "ENTER" and use the "SEL Knob" to turn
HDCP On and Off.
When HDCP is not turned on, HDCP encrypted video
sources will not be allowed to pass through PGM.
*NOTE1: During streaming and recording, PGM
content is HDCP encrypted and SDI output is disabled.
*NOTE2: When HDCP is already enabled and user
attempts to connect other HDCP devices into an
Interface ports that was previously unoccupied,
please turn the HDCP function off and then on
again to decode the signal. Otherwise, it will be
able to display in the multiview screen. User must
do this for all HDCP devices, unless devices were
connected
to AV400HD first and then turn on the
HDCP function.
56
Active
●
Advertisement
Table of Contents
