Electrical Power; Controller Setup; Power On; Selecting The Temperature Unit - PolyScience WBE20A11B Operator's Manual

1.888.610.7664

Electrical Power

WARNING: The Water Bath's power cord must be connected
to a properly grounded electrical receptacle. Make certain
that this electrical outlet is the same voltage and frequency as
your Water Bath. The correct voltage and frequency of your
Water Bath are indicated on the identification label on the
rear of the unit.
CAUTION: The use of an extension cord is not
recommended. If one is necessary, it must be properly
!
grounded and capable of handling the total wattage of the
unit. The extension cord must not cause more than a 10%
drop in voltage to the unit.
Insert the power cord into a properly grounded
electrical outlet.
Place the Mains Switch on the rear of the unit in the
On position. The three decimal points in the upper
readout light to indicate that the Water Bath is in the
Standby mode.

Controller Setup

Power On

1. Place the Mains Switch on the rear of the unit in the On position. The
three decimal points in the upper readout light to indicate that the
Water Bath is in the Standby mode.
2. Press . The actual bath temperature is displayed on the upper
readout and the set point temperature is displayed on the lower
readout. Both values are displayed to one decimal point. If the actual
bath temperature is lower than the set point temperature, the unit will
automatically begin heating and the heating symbol will light.

Selecting the Temperature Unit

1. Press until ºC or a ºF appears on the lower readout.
2. If ºC is shown, press
change it to ºC.
3. Press or allow the display to timeout (~10 seconds) to accept the
displayed temperature unit.
110-031 PSC/EN
www.calcert.com
15
10 20
5 25
0 30
to change it to ºF. If ºF is shown, press to
8
sales@calcert.com