Mitsubishi Electric PLK-J-CU-20S Technical Manual page 15

②Upgrade for Picture, Font, Language display data
(1) Please insert USB flash drive to CON W connector on PAL.
(2) Turn the power on.
► Please touch the Mitsubishi logo on the screen soon
after display the startup screen.
► It is appeared the install bar after sounds buzzer.
► In the case of a Successful installation, the install bar will turn
blue.
Note If the red LED is blinking, the installation has failed. Check
the "PLKJ_SYSTEM" folder inside the USB flash drive and
try again.
(3) Installing complete
► The buzzer beeps once and the installation is completed.
►Display is switched to standard screen after installing
complete. （When the motor axis and machine position has
already been set）
Note When setting up for the first time, the setting screen is always displayed.
Refer to "2. the motor axis and machine position setting" described later.
[6] ‐ 4