Prepare The Hood - Broan BNSC130WW Installation Use And Care Manual

Prepare the Hood

1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the finger cup or tab, remove the grease filter from the hood by pushing down

tilting filter(s) out .
B
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap (no EZ1 brackets for
BNSC1 Series). Remove both screws holding damper assembly to hood. Remove parts bag
(captured behind the damper assembly). Remove damper assembly from inside the hood and
keep the screws for further use.
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside.
C
B
C
SCR EWS
DAMPER
ASSEMBLY

and
9