Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] For BKDJ Series only: Remove 2 screws from top of hood (see illustration below). Keep
2 SCREWS
3 ] Using the finger cup, remove the grease filters from the hood by pushing down
4 ] Using a 11/32" nutdriver or socket, remove the lock nut retaining the flange of the right cover
10
the screws for further use. For BKDN and NKDN Series only: Remove the adapter/damper
from back of hood (see illustration below). Keep the screws for further use.
BKDJ Series
filters out
.
B
C
plate (shaded part on illustration below) to the inner back of hood (see inset). Remove the
right cover plate retaining screws (7 screws), then set the blower cover along with its screws
and nut aside.
B
5
4
6
1
7
BACK OF HOOD
LOCK NUT
BKDN and NKDN Series
2 SCREWS
C
3
2
and tilting