Setting The Saw Chain - Echo CS-3510 Operator's Manual

MAINTENANCE
8. Start engine, and allow unit to warm up at idle for several minutes.
9. Stop engine, and re-tighten mounting bolts (or nuts) to 7 - 9 N•m (60-80
in•lbf).
10. Install guide bar and chain. Adjust chain tension.
11. Start engine and check for exhaust leaks between muffler and cylinder
head. Stop engine if leak is found and correct problem before operating
chain saw.

Setting The Saw Chain

Drive Link
Tie Strap
Right Hand Cutter
Important points for proper maintenance of saw chain:
• Keep the cutters sharp at all times.
• Keep the left and the right cutters properly aligned.
• Note that blunt or irregular cutters will result in poor cutting performance,
increased vibration of chains and premature breakage of the saw chain.
• Drive link serves to remove
sawdust from the groove of the
guide bar. Keep the lower edge of
the drive link sharp where
indicated.
50
Preset Tie Strap
Guard
Link
CS-3510
Left Hand Cutter
Top
Plate
Side
Plate
Sharpen lower edge
X7503360201
© 8/20 ECHO Incorporated
Depth
Gage