Starting Warm Engine - Echo CS-3510 Operator's Manual

OPERATION
After choke control knob is pulled and then knob is
◆
returned to original position, throttle remains slightly open
(fast idle latch condition).
The chain will attempt to move when engine is started with
◆
fast idle throttle latch engaged.
Do not start engine before chain brake is locked.
◆
6. Securely hold the chain saw and pull starter handle several times until
first starting sound.
7. Push choke control knob (B) all the way IN (OPEN
8. Pull starter handle to start the
engine.
Note: Do not pull starter rope out to
the maximum possible
position.
Note: Do not allow recoil handle to
snap back against the
casing.
Note: If engine does not start after 5 pulls, repeat instructions.
After starting the engine, immediately squeeze and then
◆
release throttle trigger to release fast idle throttle latch,
otherwise severe brake damage may occur.
Never use fast idle throttle latch for cutting.
◆
Use the fast idle throttle latch only in starting.
◆
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.

Starting Warm Engine

Make sure the bar and chain are free from any obstruction when
starting the chain saw.
32
CS-3510
choke position).
X7503360201
© 8/20 ECHO Incorporated