Table of Contents
Advertisement
TCP/IP Configuration
Configuring LAN Interface
Configuring DHCP Server
To use the DHCP server inside the device, please make sure there is no other DHCP server that exists in the same network as
the device.
Enable the DHCP Server option and assign the client range of IP addresses as shown in the following page.
When the DHCP server is enabled and also the device router mode is enabled then the default gateway for all the DHCP client
hosts will be set to the IP address of device.
Configuring WAN Interface
The device supports four kinds of IP configuration for WAN interface, including Static IP, DHCP Client, PPPoE and PPTP. You
can select one of the WAN Access Types depending on the requirements of your ISP. The default WAN Access Type is "Static
IP".
36
Advertisement
Table of Contents
