Wds Point-To-Point Link - Deliberant DLB27 Series User Manual

Under TCP/IP > WAN Interface, the WAN connection needs to be set up. This specifies how the AP client will communicate
with the network behind the remote access point. In this case DHCP client is used, and the WAN IP address is obtained from
the remote access point.
The next step is configuring the TCP/IP > LAN interface. This defines what happens to any connections made through the
ethernet port. In this case DHCP server is enabled, so any connections made will be assigned an IP in the range of
192.168.2.100-200.
To make sure everything is connected correctly, go to the Status page in the Management section.

WDS Point-to-Point Link

This example explains how to set up a bridged WDS point-to-point link. Two units are required for this example (radio A and
radio B).
14