Monitor Section - Yamaha M3000A Owner's Manual

Monitor section

A
C
D
E
F
In this section you can select the signal which will be
monitored from the MONITOR OUT jacks and the
PHONES jack. The following signals can be selected
as monitor sources.
Signals which can be selected as monitor
sources
Signals
CH PFL
SW
CH PFL
MASTER
N/A
AFL
2TR IN N/A
(Note) N/A: There is no ON/OFF condition.
* When all switches are turned off, you can monitor AFL
signals from ST OUT A.
* When MASTER PFL (3) is turned on, the MASTER AFL
signal becomes a PFL signal,
INPUT
B
MASTER
MASTER
PFL
L+R
2
1/
ON
2TR IN
MASTER
ST OUT A 2TR IN
AFL
N/A
A INPUT indicator
This indicator will light if even one of the input chan-
nel PFL switches are turned on.
B MASTER indicator
This indicator will light if even one of the AFL
switches of the mix section, STEREO A section, STE-
REO B section, or matrix section (page 24) are turned
on.
C MASTER PFL switch
This switch selects the master signal (the signal of
either the MAS AFL bus or the MAS PFL bus) which
will be monitored by the MONITOR jacks or
PHONES jack. When the MASTER PFL switch is on
( ) the signal of the MAS PFL bus will be moni-
tored. When this switch is off (
MAS AFL bus will be monitored.
D L+R switch
When this switch is on (
is output from the MONITOR OUT jacks and the
PHONES jack will be mixed to a monaural signal.
E 1/ 2 select switch
This switches between the two sets of 2TR IN jacks
located on the rear panel. When the switch is in the
upward position ( ) the 2TR IN 1 jacks are selected,
and when the switch is in the downward position
( ) the 2TR IN 2 jacks are selected.
F ON switch
This switch sends the input signal from the set of 2TR
IN jacks selected by the 1/2 select switch to the MON-
ITOR jacks and PHONES jack. When this switch is
pressed ( ), the input signal from the selected pair
of 2TR IN jacks will be sent to the MONITOR jacks
and PHONES jack.
Control panel
), the signal of the
), the monitor signal which
19