Yamaha M3000A Owner's Manual page 17

A
TO MATRIX
STEREO A
CHECK
B
ON
ON/EDIT
C
AFL
STEREO A
10
5
0
5
10
20
30
40
50
D
60
A TO MATRIX switch
When this switch is on (
fader signal is sent to the matrix.
B ON/EDIT switch
The function of this switch and indicator will depend
on the mode of the M3000A.
In normal mode
The ON/EDIT switch will turn ST OUT A on/off.
When on, the ON indicator will light. When off, no
signal will be sent to the ST OUT A jacks, MONITOR
OUT jacks, PHONES jack, MAS AFL bus, or the
matrix. However even in this case, you can turn on the
AFL switch (3) to monitor the pre-fader signal from
the MONITOR OUT jacks or the PHONE jack.
In check mode
You can use the CHECK indicator to view the on/off
status of ST OUT A stored in a scene before you actu-
ally recall the scene.
In check mode, you can also use the ON/EDIT switch
to change only the lit/dark status of the CHECK indi-
cator. (The actual on/off setting will not be affected.)
C AFL switch
This switch allows the ST OUT A signal which is sent
to the ST OUT A jacks or to the matrix to be moni-
tored from the MONITOR OUT jacks or from the
PHONES jack. When this switch is on (
cator will light, and the pre-fader signal will be sent to
the MAS PFL bus and the post-fader signal will be
sent to the MAS AFL bus, allowing you to monitor
them from the MONITOR OUT jacks or the
PHONES jack.
When the master section MASTER PFL switch
(page 19) is off you can monitor the signal of the MAS
AFL bus, and when it is on you can monitor the signal
of the MAS PFL bus. However if even one of the PFL
switches of the input channels is turned on, the signal
of the PFL bus will take priority for monitoring, and it
will not be possible to monitor ST OUT A.
D ST (stereo) fader
This fader adjusts the final output level of ST OUT A.
This fader affects the level of the signal which is sent
to the ST OUT A jacks, the MONITOR OUT jacks,
the PHONES jack, the MAS AFL bus, and the matrix.
Control panel
), the ST OUT A post-
), the indi-
17