Yamaha M3000A Owner's Manual page 11

G M1–M8 mix level controls
These controls combine the stereo signal from the ste-
reo input channel into a mono signal, and send it to
MIX buses 1–8. When the control is in the " " posi-
tion, the level is nominal (0 dB). Use the PRE switch
(M) to switch between pre/post fader.
Note: For MIX bus pairs for which the variable/fix
select section (page 13) switch is set to FIX, the out-
put level which is sent from each input channel to
the bus will be fixed, and therefore the mix level
control setting will have no effect.
H M9–M12 switches
These are on/off switches for the signals that are sent
from the stereo input channel to MIX buses 9–12.
I M9–M12 mix level controls
These controls combine the stereo signal from the ste-
reo input channel into a mono signal, and send it to
MIX buses 9–12. When the control is in the " " posi-
tion, the level is nominal (0 dB). Use the PRE switch
(M) to switch between pre/post fader.
A
L HA
B
INPUT A
R HA
ST CH
1-4
L HA
INPUT B
R HA
PEAK
NOM
SIGNAL
VCA
4 Stage EQ
EQ
VCA
4 Stage EQ
1
2
from VCA Master
7
8
CHECK ON
from Ctrl Master CONTROL
ON/EDIT
J M13/M14, M15/M16 switches
These are on/off switches for the signals that are sent
from the stereo input channel to MIX buses 13–16.
M13 and 14, and M15 and M16 are stereo pairs, and
each pair is turned on/off by one switch.
K M13/M14, M15/M16 mix level controls
These controls send the stereo signal from the stereo
input channel to MIX buses 13/14, 15/16. When the
control is in the " " position, the level is nominal (0
dB). M13 and M14, and M15 and M16 are stereo
pairs, and the output level of each pair is controlled by
one knob. Use the PRE switch (P) to switch between
pre/post fader.
L M13/M14, M15/M16 BAL (balance) controls
These controls set the left/right balance of the signals
that are sent from the stereo input channel to MIX
buses 13/14 or MIX buses 15/16.
M PRE switches
These are pre-fader/post-fader switches for the signals
that are sent from the stereo input channel to the MIX
buses. Pre/post can be switched independently for
each group of MIX buses: 1–4, 5–8, 9–12, and 13–16.
When the switch is pressed (
EQ signal will be sent to the corresponding group of
MIX buses.
1 3
2
ST BAL
M1
M2
PRE
M3
M4
M5
M6
PRE
M7
M8
M9
M10
M11
PRE
M12
M13
BAL
M14
PRE
M15
BAL
M16
PFL
Control panel
), the pre-fader/post-
MIX MIX
(VARIABLE) (FIX)
PFL
5 7 9 11 13 15 1 2 3 4 5 6 7 8 L R ON
4 6 8 10 12 14 16
ST
L R
11