Yamaha EMX860ST Owner's Manual page 11

5
AUX IN/TAPE IN jacks
These are input jacks that allow the signal from
an external device to be added to the MAIN out-
put.
• AUX IN jacks: Connect these jacks to the
output jacks of an external effects processor.
If the effects processor has a stereo output,
connect it to the AUX IN L (MONO) and R
jacks. If it has monaural output, use the AUX
IN L (MONO) jack. Signal input to these
jacks is sent to the ST bus.
• TAPE IN jacks: Use these jacks to connect a
stereo device, such as a cassette player or a
CD player. The signals input to these jacks is
sent to the ST bus.
The nominal input level and impedance are –10 dB/
600 for the AUX IN jack, and –10 dBV/600
for the TAPE IN jacks.
6
REC OUT/MONITOR/MAIN (STEREO)
jacks
These are output jacks which send line level sig-
nals from the EMX860ST to external devices. A
stereo recording device such as a cassette recorder
or MD recorder can be connected to the REC
OUT jacks, and a playback device such a power
amp can be connected to the MONITOR and
MAIN (STEREO) jacks. The signals sent from
each jack are as follows.
• REC OUT jacks: The ST bus signal before it
has passed through the MASTER control
and graphic equalizer
• MONITOR jack: The MONI bus signal
which has passed through the Monitor MAS-
TER control and graphic equalizer
• MAIN (STEREO) jack: The ST bus signal
which has passed through the Main MAS-
TER control and graphic equalizer
The nominal output level and impedance are
–10 dBV/10 k for the REC OUT jacks, and
+4 dB/10 k for the MONITOR/MAIN (STE-
REO) jacks.
11
Input/output panel
EMX860ST—Owner's Manual