Advertisement
6. TROUBLESHOOTING
This produce complies with the relevant regulations governing the safety of electrical equipment. For
safety reasons, any technical inspections or repairs must be performed by qualified staff, to prevent all
hazards for the user.
If the appliance does not work, before calling the After-Sales Service, to avoid unnecessary expense,
check yourself that the operations listed in this troubleshooting table have been carried out..
1
Appliance does not start
2
No water filling
3
No water visible in wash-
ing drum
4
Water not pumped out
5
Water not pumped out
after last rinse in deli-
cate fabrics and wool
wash programmes
6
Water
takes
pumps out water contin-
ually
7
Strong vibrations during
spins
8
Too much foam formed
in tank and flowing out
of drawer
9
Water on floor
Check that:
- plug is properly connected to socket
- door is securely closed
- "Start/Pause" button has been pressed.
Check that:
-
plug is properly connected to socket
-
door is securely closed
-
water tap is turned on
-
water intake hose filters not fouled.
-
water intake hose not trapped or kinked.
No malfunction.
The water level is below the level of the glass in the door because
new appliances use very little water to achieve the same washing
and rinsing results.
Check that:
-
drain hose is not kinked
-
drain pump not fouled.
It is not a malfunction: pause programmed into washing pro-
gramme to prevent creasing of fabrics.
To pump out water, proceed as described in "Programme End"
point.
in
and
Check that end of drain hose is not too low down.
Check that:
Appliance is properly levelled
-
washing machine not too close to walls or kitchen units
-
-
internal unit on flexible mounts locked in position.
Check that:
-
detergent used is recommended for automatic washing ma-
chines and not for hand washing
quantity used is as stated in manual and no more
-
Check that:
-
water intake hose fittings not loose
-
end of drain hose still correctly positioned.
EN
24
Advertisement
