Battery Installation And Charging - AT&T CL80067 User Manual

Getting started

Battery installation and charging

Install the battery, as shown on page 8. Once you have installed the
battery, the screen indicates the battery status (see the following
table). If necessary, place the handset in the telephone base or
charger to charge the battery. For best performance, keep the
handset in the telephone base or charger when not in use. The
battery is fully charged after 10 hours of continuous charging. See
the table on page 38 for battery operating times.
If the screen shows Place in charger and flashes, you need to
charge the handset without interruption for at least 30 minutes to
give the handset enough charge to use the telephone for a short
time. The following table summarizes the battery charge indicators
and actions to take.
Battery indicators
The screen is blank, or
shows Put in charger
and (flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HANDSET X.
Note: If you are on a phone call in low battery mode, you hear four short beeps every minute.
Battery status
Battery has no or
very little charge. The
handset cannot be
used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
7
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
telephone base or charger
when not in use.