Logger Menu And Navigation - Grant OQ610-S Getting Started

4.1 Introduction
The OQ610 comes pre-programmed with a default setup providing a basic setup without the
need to use any software. Default settings are as follows:-
Logging results may be evaluated immediately by directly connecting to a printer (see
section 7). In addition, the logger can be set up with 'Cure parameters' for a percentage
cure readout (see software Help content for more details)
4.2 Overview of the operating buttons
The operating buttons allow the set up of all of the major functions of the logger.
Selects the function
Important Notes:
Version 12
Page 5

4. Logger Menu and Navigation

K-Type -200 to 1300°C
Logging interval every two seconds
Record up to eight runs before overwriting the oldest.
Func
Setup changes are not allowed whilst logging
When using the software, the Set button also wakes the Logger for
communication when instructed/required
The logger memory is divided up into a number of runs. When all the runs are
completed, start logging will automatically overwrite the oldest. It is not
necessary to clear any runs in the memory unless specifically required
Only use the reset function on recommendation from technical support
www.grantinstruments.com
Sel
Chooses the channel
or sub-function
Set
Changes any
of the settings
28123