Getting Started With The Software - Grant OQ610-S Getting Started

5. Getting Started with the Software

5.1 Installing the software
Install the software from the USB drive by following the on-screen instructions.
Important: Please ensure the software is installed before connecting the Squirrel
data logger.
5.2 Connecting the Squirrel data logger
Connect one end of the supplied USB lead to the logger and the other end to the PC.
On detection of the logger the PC will install the Grant Instruments OQ610 USB device
Important information
Only use a USB cable up to 3m in length to maintain CE compliance
Win 7,8,10 - USB Device Drivers are automatically installed and no further action is
required
5.3 Startup SquirrelView\PaintView and Select Logger Type
Click on the shortcut icon on your desktop to launch SquirrelView\PaintView or select it
from your start menu. When the SquirrelView\PaintView Assistant is loaded, ensure
the correct logger type and communication method is selected. This can be viewed in
the top right corner of the screen. If you need to make any changes select Logger Se-
lection from the
Assistant toolbar or run the Communication Wizard.
5.4 Synchronise Logger & PC
It is advisable to start by synchronising the Logger clock with the PC clock. See step 1
and 2 below:
Synchronise clocks:
From
SquirrelView\PaintView
Assistant click on Logger
Setup.
Version 12
Page 9
From the Logger
Setup screen select
the Logger Control
tab.
Click on Set Logger
Time to PC Time, click
OK on the confirma-
tion screen.
www.grantinstruments.com
28123