Customization Basics; 3/4" Overlay Panel Dimensions - Flush - GE Monogram ZIRP360NHLH Installation Instructions Manual

Table of Contents

Advertisement

CUSTOMIZATION BASICS:

Framed Or Overlay Panels, Custom
Handles and Accessory Kits
Professional Style Stainless Steel Models
Stainless steel wrapped refrigerators have beveled
edges and professional-style handles. These models are
shipped ready for installation.
Stainless Steel Wrapped Models
Stainless Steel wrapped models have wrapped doors
and grille panel, beveled edges, and tubular stainless
steel handles that coordinate with other Monogram
appliances. These models are shipped ready for
installation.
Trimmed Models
Trimmed models are designed to be customized with
decorative panels. Field installed custom door and grille
panels are required.
3/4" OVERLAY PANEL DIMENSIONS
(Flush Installation Only)
For a more custom appearance, overlay panels may be
installed to give a flush appearance with surrounding
cabinets. The overlay panel must be 3/4" thick. Panel
attaches to included brackets to provide mounting to the
appliance door.
38"
9-5/8"
Grille Panel
Door
69-13/16"
Panel
IMPORTANT NOTE: Maximum total weight for the assembled
panels:
Door panel – 67 lbs.
WARNING
Door Trim Pinch Point Hazard
Improper installation can lead to a finger pinch
point hazard between the side door trim and the
cabinets when operating the door, especially
with children. To minimize this risk you must
follow the installation instructions for cabinet
dimensions, trim assembly, and door stop angle.
Design Guide
Top/Bottom Hinge
Clearance
Router 1/8" Deep
1"
1-1/4"
1"
1-1/4"
Grille Panel – 18 lbs.
Optional Accessory Kits
• ZKHSS2: Monogram Tubular Stainless Steel handles
designed to fit 3/4" overlay panels.
• ZKHPSS1: Pro Tubular Stainless Steel handle designed
to fit 3/4" overlay panels.
• ZUG2: For side-by-side installation of two trimmed
models. This kit provides for the installation of a unified
custom grille panel to span the width of two units
using a framed or overlay panel.
• ZUGSS2: For side-by-side installation of two stainless
steel wrapped models. This kit provides a unified
stainless steel grille panel to span the width of two
units.
• ZTK36SDRHH: Trim kit for standard installation using
custom panels. This kit is for use with a right hand door
swing.
• ZTK36SDLHH: Trim kit for standard installation using
custom panels. This kit is for use with a left hand door
swing.
CUSTOM HANDLE DESIGN GUIDE
(Flush Installation Only)
For custom handle installation, counterbore holes in
rear of decorative panels may not exceed 1/4" depth
to ensure 1/2" material thickness remains for handle
support. NOTE: The counterbore must not exceed 1" in
diameter.
1/2"
Minimum distance from
handle side edge to handle
center should be 2-1/2" as
shown.
1/2"
8
1/2"
1/4"
3/4"
2-1/2"

Advertisement

Table of Contents
loading

Table of Contents