Xerox 128 Operator's Manual page 154

Technical information
5- 8
Table 5-5. Satisfaction guide for various stocks
Stock Type
Substance 13
(49 g/m2) paper
Substance 16 (60 g/
m2) paper
Substance 20 (75 g/
m2) paper
Card stock
Xerox substance 65
(176 g/m2)
Substance 110 (200 g/
m2) long grain (index)
Xerox 4024, substance
20
(75 g/m2)
3 hole drilled
4 hole drilled
7 hole drilled
Never-tear, 3 hole
drilled
Never-tear
DocuTech 128/155/180 HighLight Color Operator Guide
Instructions for use
Use trays 3,4,or 5.
Do not run 2-sided prints.
Load the paper with seam side down into tray
3.
Optimum satisfaction can be expected with
8.5 x 11 inch (216 x 279 mm) or larger paper.
Load paper with seam side up into trays 1
and 2; seam side down into tray 3, 4, or 5.
Optimum satisfaction can be expected from
tray 3, 4, or 5.
Load the paper with seam side up into trays 1
and 2; seam side down into trays 3, 4, and 5.
Card stock can be run from any tray.
Reduce set size if frequent paper jams or
bindexer jams occur. If collated unfinished,
another solution is to lower the value of the
bindexer capacity set in the SWITCHES
mode.
Load the paper into trays 1 and 2 with holes
to the right; load the paper into trays 3, 4, and
5 with holes to the left.
Use the Image Shift or Reduce/Enlarge
options to avoid printing near the holes.
Fan the paper and check the paper for loose
paper plugs before loading the paper into the
trays.
Load the paper into trays 1 and 2 with holes
to the right; load the paper into trays 3, 4, and
5 with holes to the left.
Do not bind or run 2-sided prints.
Do not bind or run 2-sided prints.