Table of Contents
Advertisement
Symptoms
Door does not
open
Wash cycle time
delayed
The buttons may
not function
properly.
Dry problem
A shortage alert
appears even
after you filled
the dispensers
for the detergent
and softener.
Drying
performance is
too low or bad.
Drying time is
too long.
Clothes are
strong-wrinkled.
56
Reason
Once washing machine has started,
the door cannot be opened for
safety reasons.
If an imbalance is detected or if the
suds removing programme is on,
the wash time will increase.
The button cannot be recognized
when the door is open.
Check water supply tap.
Are all the feet resting firmly on the
ground?
Did you supplement the detergent
and softener before you got the
shortage notification?
Water is not properly supplied. The
water is used for auto-cleaning of
lint-filter on drum during the drying.
Water does not properly drain.
The appliance is overloaded.
The spin speed is too low.
The ambient temperature is low.
Clothes are over-dried.
Clothes are left in the drum for a
long time after drying.
Solution
• Check if the 'Door Lock' icon is
illuminated. You can safely open the
door after the 'Door Lock' icon turns
off.
• This is normal. The time remaining
shown in the display is only an
estimate. Actual time may vary.
• Press again after closing the door.
• Do not overload. Check that the
washing machine is draining properly
to extract adequate water from the
load. Clothes load is too small to
tumble properly. Add a few towels.
• Turn off water supply tap.
• Make sure that all four feet are
stable.
• When a washing programme is
ended, the washing machine detects
whether it is necessary to refill the
detergent. Therefore, no alarm
appears until the next refill alarm
does.
• Make sure the water supply tap is
open.
• Make sure the drain filter is not
clogged.
• Check the load capacity for the
selected cycle. If necessary, add a
Time Dry cycle.
• Select the highest spin speed allowed
for the wash cycle.
• Make sure the temperature
is allowable range. (Refer to
'Specifications' of installation page.)
• Select suitable drying course.
• Remove laundry from the drum as
soon as possible after the cycle ends.
EN
Advertisement
Table of Contents
