Table of Contents
Advertisement
Delay Wash(
You can set a time delay so that the washing
machine will start automatically and finish after
a specified time interval.
1
Press the Power button.
2
Select a washing programme.
3
Press Delay Wash (
programme.
4
When you want to change the time, touch
the display.
5
Set Est. End Time.
6
Press the OK button.
NOTE
• The delay time is the time up until the
end of the programme, not the start. The
actual running time may vary due to water
temperature, wash load and other factors.
• When the Delay Wash has been set, the
remaining time appears on the display.
• The delay time can be set up to 24 hours
from now and cannot be set if it is within the
minimum hours of a wash programme.
• To cancel the Delay Wash function, the Power
button should be pressed.
)
) under the
Add Item
Laundry can be added or removed after the
washing programme is started.
1
Press the Start/Pause button.
2
Press the Add Item.
3
Open the door after door lock is released.
4
Add or remove laundry.
5
Press the Start/Pause button again to
continue the cycle. The cycle continues
automatically.
NOTE
• For safety reasons, the door remains locked
when the water level or temperature is high. It
is not possible to add laundry during this time.
• If the water temperature in the drum is high,
wait until it cools down.
CAUTION
• When adding laundry, make sure to
completely push it into the drum. If laundry
gets stuck in the door latch hole, the rubber
packing may be damaged, causing water
leakage and malfunction.
• Forcing the door open may cause part
damage, destruction, or safety problems.
• If you open the door while there are a lot of
suds and water in the drum, the suds or water
may flow, causing burn injury or wet floor.
EN
37
Advertisement
Table of Contents
