Table of Contents
Advertisement
Door Reversal
If required the door can be reversed, hinged from the left,
opening from the right.
To reverse the bottom hinge assembly proceed as follows:
Disconnect the appliance from the electricity supply.
Tilt the appliance backwards, resting the top edge of the
appliance on a stool or something similar.
Unscrew the 2 adjustable feet. Unscrew the 2 screws
holding the lower door bracket. transfer the lower door
hinge pin to the alternative position as shown in the top
drawing. Unscrew the single screw at the bottom left
hand side and retain . Replace the lower door bracket on
the bottom left hand side but do not fully tighten the 3
screws.
Remove the fridge door by gently pulling downwards and
store to avoid damage.
Unscrew the top door hinge pin of the refrigerator then
screw it back on the other side. As shown in the second
drawing.
Replace the fridge door on the upper door hinge pin.
Insert the lower door hinge pin into the door and tighten
all screws.
Re-fix the retained screw to the bottom right hand side
and replace the 2 adjustable feet.
Lift the fridge back onto its feet and check it is set level
and the door seal meets the fridge all around the door.
Unscrew the handles and fix them on the opposite side.
Reconnect the fridge to the electricity supply.
Do a final check to make sure that:
All screws are tightened.
The magnetic seal adheres to the cabinet.
The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After Sales
Service Force.The After Sales Service specialist will carry
out the reversibility of the doors at your cost.
8
Advertisement
Table of Contents
