Speedboost ® Function; Panel Lock; Wipe Protection; Automatic Time Limitation - Bosch NIT5668UC Use And Care Manual

SpeedBoost function
®
The SpeedBoost function can be used to heat large
®
amounts of water faster than by using heat level
Limitation on use
This function can always be activated for an element,
provided the other element in the same group is not in
use (see illustration). Otherwise,
display for the selected element; heat setting
be set automatically without activating the function.
Activation
Select an element.
1.
Touch the Speed Boost key.
2.
lights up on the display.
›
The function is activated.
Deactivation
Select the element on which SpeedBoost
1.
Touch the Speed Boost key.
2.
goes out on the display and the element switched
›
back to heat setting
Š
The function is deactivated.
Note: In certain circumstances, the function may be
deactivated automatically to protect the internal
electronic components of the cooktop.

Panel lock

You can use the panel lock to prevent children from
accidentally turning the cooktop on.
Turning the panel lock on
The cooktop must be turned off.
Touch Panel Lock for 4 seconds. The
Panel Lock lights up for 10 seconds. The cooktop is now
locked.
Turning the panel lock off
Touch Panel Lock for 4 seconds. The child lock is now
deactivated.
CAUTION
9
The panel lock may be accidentally turned on and
off due to:
water spilled during cleaning
▯
food that has overflowed
▯
objects being placed on the Panel Lock key.
▯
14
and will flash in the
› Š
will then
Š
is set.
®
.
indicator over
Ú
Automatic panel lock
With this function, the panel lock is automatically
activated whenever you turn off the cooktop.
.
Š
Switching on and off: You can find out how to switch the
automatic panel lock on in the section ~ "Basic
settings"

Wipe Protection

Cleaning the control panel while the cooktop is on may
change the settings. In order to avoid this the cooktop
has a wipe protection function.
To activate: Touch the Panel Lock key. The
above the key lights up. The control panel is locked for
35 seconds.
You can now clean the surface of the control panel
without risk of changing the settings.
To deactivate: To deactivate the function before the time
has elapsed, touch the Panel Lock key. The
above the key turns off, the function is deactivated.
Notes
An acoustic signal sounds 30 seconds after activation.
▯
This indicates that the function is about to finish.
The wipe protection function does not lock the main
▯
switch. The cooktop can be switched off at any time.

Automatic time limitation

If the element is used for prolonged periods of time
without changes in the settings being made, the
automatic time limitation function is triggered.
The element stops heating.
indicator • /
The indicator goes out when any symbol is pressed. The
element can now be reset.
When the automatic time limitation is activated depends
on the selected heat level (from 1 to 10 hours).
and the residual heat
"‰
œ flash alternately in the display.
indicator
Ú
indicator
Ú