Table of Contents
Advertisement
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start the
Drain programme.
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme
2.
(except Rinse/Spin/Empty).
Press the Ü button. Allow the
3.
programme to run for approximately
40 seconds.
Press the # button. The appliance is
4.
switched off.
Pull out the mains plug.
5.
Cleaning and maintenance
Then clean the filter:
Disconnect the hose from the tap.
1.
Clean the filter with a small brush.
For standard and Aqua-Secure
2.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
3.
leaks.
en
45
Advertisement
Table of Contents
