Programme default settings
en
Notes
Leave the door and detergent
■
drawer open slightly when the
appliance is not in use. ~ Page 43
The active oxygen treatment is less
■
effective if the drum is dirty. Run the
Drum Clean î (limp. tambor î)
programme regularly.
It is not possible to add laundry once
■
the programme has started.
If you cancel the programme or
■
switch to a different one, the door
will remain locked until there is no
longer any active oxygen in the
drum. This make take up to
25 minutes. The two symbols Ï and
î will flash during this time. The
door will then unlock automatically.
Starching
Laundry should not be treated
Note:
with fabric softener.
Liquid starch can be used to stiffen
fabrics particularly in the Rinse and
Cottons programmes. Measure starch
into compartment M in accordance with
the manufacturer's instructions (clean
first if necessary).
Dyeing/bleaching
Dye should only be used in normal
household quantities. Salt may damage
stainless steel. Always follow the dye
manufacturer's instructions.
Do not use the washing machine to
bleach clothes.
34
Soaking
Switch on the appliance.
1.
Select the Cottons 30 °C
2.
programme.
Pour soaking agent/detergent into
3.
compartment II in accordance with
the manufacturer's instructions.
Press the Ü button. The programme
4.
starts.
After approx. 10 minutes, press the
5.
Ü button to pause the programme.
Leave the laundry to soak for as long
6.
as required, then either press the Ü
button again to continue the
programme or change the
programme.
Notes
Load laundry of the same colour.
■
No additional detergent is required;
■
the soaking solution is used for
washing.
0
Programme default
settings
The default programme settings are
P r o g r a m m e d e f a u l t s e t t i n g s
displayed in the display panel after
selecting the programme.
You can change the default settings.
An overview of all programme settings,
which can be selected depending on
the programme, can be found from
~ Page 29.