Plantronics PRACTICA T110 User Manual page 3

Important Safety Instructions
WARNING: To reduce the risk of
fire or injury to persons, read and
follow these instructions.
• Avoid using the Practica T110
headset telephone during electrical
storms in your immediate area.
There is a risk of electric shock
from lightning.
• Do not use headphones / headsets
at high volumes for an extended
period of time. Doing so can cause
hearing loss. Always listen at
moderate levels.
• If you experience skin irritation
after using this product, discontinue
use and contact Plantronics.
• CHILDREN. Never allow children to
play with the product—small parts
may be a choking hazard.
Installation
The Practica T110 is a complete
headset telephone which can be con-
nected to any wall jack with an RJ11
modular jack.
1. Plug one end of the modular
telephone line cord (supplied) into
your telephone wall jack.
2. Plug the other end of the modular
telephone line cord into the jack on
the back of the Practica T110 (1).
3. Insert the plug from the headset
cord into the jack on the front
of the Practica T110 (9) with the
HEADSET icon.
IMPORTANT: AFTER INSTALLING
YOUR PRACTICA T110 TELEPHONE,
IT IS NECESSARY TO WAIT 10 SEC-
ONDS FOR IT TO INITIALIZE PRIOR
TO USING IT FOR THE FIRST TIME.
4
Headset Operation
The Practica T110 headset is sup-
plied with a high quality microphone
to provide clear voice communica-
tions.
The boom mic can be swiveled to
position the headset on either your
right or left ear.
Place the headband over your head
with the speaker positioned over the
ear of your preference. With one hand
grasp and hold the ear cushion to
steady, and carefully pull the boom
mic down and into position so that
the mic is in front or slightly to the
side of your mouth. Position the mic
about an inch from your mouth.
NOTE: Do not twist the mic on the
end of the boom as this may damage
the internal wiring.
Use the clothing clip to attach the
cord to your lapel or collar and out
of your way. Leave enough slack in
the cord so that you can move your
head freely with out dislodging the
headset.
To Make an Outgoing Call
Put the Headset on and adjust for
comfort. Adjust boom mic so that it
is about the width of two fingers from
your mouth. Push the TALK BUTTON
(5). You should now hear a dial tone
in your Headset speaker and the "IN
USE" LED will light. You can move
the VOLUME control to adjust the dial
tone volume to a comfortable sound
level. Using the dial pad of your
Practica T110, dial the number you
want to call. You should hear the
numbers dialing in your Headset
speaker. After completing your con-
versation, push the TALK BUTTON (5)
again to hang up and disconnect the
call. The "IN USE" LED will go out.
To Answer an Incoming Call
When you hear an incoming call ring
at your Practica T110 telephone,
push the TALK BUTTON (5) and the
Practica T110 telephone will go off
hook and the "IN USE" LED will light.
After completing your conversation,
push the TALK BUTTON (5) again to
hang up the phone. The "IN USE"
LED will go out.
To mute the Practica T110, press the
mute switch, this will mute both the
agent and the superviser. The mute
LED will light up. To unmute, press
this again and the LED will turn off.
Note
For warranty, service or assistance,
contact your local distributor.
5