Wake Activation Area (Photocell Led Output) - Honeywell METROLOGIC Stratos MS2422 Installation And User Manual

Wake Activation Area (Photocell LED Output)

The MS2421/MS2422/MS2431 scanner's default power save mode
(see page 41). This power save mode turns the laser OFF after a configured period of non-use then turns
the motor OFF after thirty-minute intervals. Any movement detected by the photocell in the activation area,
shown below in grey, will cause the scanner to exit the power save mode. The motor will restart
automatically and the laser will turn back on preparing the scanner for bar code recognition, decoding, and
transmission.
Figure 31. Wake Activation Area Perpendicular to Package Flow Default Range
†
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power
save modes.
Specifications are subject to change without notice.
(Photocell LED Output)
†
is Dual Action Power Save Mode #2
33