Neutral Adjustment; Motion Control Damper Adjustment; Motion Control Neutral Lock Pivot Adjustment - Encore CALIBER EC52FX801V4 Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

4. Temporarily install a jumper wire across

the terminals in the connector of the main

wiring harness.

5. Start engine. Brake must be engaged and

motion control levers out to start engine.

Operator does not have to be in the seat

because of the jumper wire being used.

Run engine at full throttle and release brake.

6. Run the unit at least 5 minutes with the

drive levers at full forward speed to bring

hydraulic oil up to operating temperature.

Note: The motion control lever needs to be

in neutral while making any necessary

adjustments

7. Bring the motion control levers into the

neutral position. Adjust pump control rod

lengths by rotating the double nuts on the

rod in the appropriate direction until the

wheels slightly creep in reverse. See figure

below. Move the motion control levers to

the reverse position and while applying

slight pressure to the lever allow the RTN

springs to bring the levers back to neutral.

The wheels must stop turning or slightly

creep in reverse.

8. Shut off unit. Remove jumper wire from

wire harness and plug connector into seat

switch.

9. Remove the jack stands.

10. Raise the deck and re-install the height of

cut pin.

11. Check that the machine does not ccreep in

neutral with the park brakes disengaged.