Channel Set - Panasonic SC-HT800V Operating Instructions Manual

CHANNEL SET

The unit tunes automatically after you plug it in and turn it on for the first time (➡ page 15, Plug-in Auto Tuning), but you can start the process
again if necessary.
≥Make sure you have tuned to a television channel. This does not work if you have selected "AU" channel.
While the VCR MENU is displayed
1
Press [3, 4] to select "CHANNEL SET" and press [ENTER].
ANTENNA SYSTEM
2
Press [3, 4] to select "ANTENNA
SYSTEM" and press [ENTER].
3
Press [3, 4] to select "TV" or
"CATV" to suit the type of antenna
you are using.
ANTENNA SYSTEM
≥ TV
SELECT:
END
Channels are set corresponding to the antenna system you select.
This is set automatically when you do Plug-in Auto Tuning.
To exit the settings screen
Press [MENU] until the screen disappears.
AUTO
Auto tuning searches for TV stations and memorizes every tuned
program position. Other program positions are skipped. (Channel
range ➡ right)
2
Press [3, 4] to select "AUTO" and
press [ENTER].
Auto tuning starts. It takes three or more minutes to complete.
AUTO CHANNEL SET
PROCEEDING
END
To stop partway through
Press [MENU].
CATV
:
3 4
:MENU
2
:MENU
[Remember]
MANUAL
You can manually preset channels that are skipped when using the
auto channel setting, and manually skip channels that are preset.
2
Press [3, 4] to select "MANUAL" and
press [ENTER].
3
Press [3, 4] to select "CH" and
[2, 1] to select the channel.
4
Press [3, 4] to select "BLANK" and
[2, 1] to select "ON" or "OFF".
MANUAL CHANNEL SET
CH
BLANK
SELECT
END
To exit the settings screen
Press [MENU] until the screen disappears.
∫ Channel range
≥TV mode
Band
VHF
UHF
≥CATV mode
Band
VHF
CATV LOW BAND
CATV MID/SUPER BAND
CATV HYPER BAND
ULTRA BAND
SPECIAL CATV CHANNEL
Press [VCR] first.
2
ON OFF
¥
:
s/r:
4 3 2 1
:MENU
Airwaves
2–13
14–69
Cable
2–13
95–99
14–36
37–65
66–94
100–125
1
RQT6951
43