SImx Pukaki LHT1111 Installation Instructions

INSTALLATION INSTRUCTIONS
PUKAKI
LHT1111 ANTHRACITE / LHT1112 WHITE
10W LED Wall Light
The Simx Lighting Pukaki Wall Light is a contemporary design, high quality LED luminaire.
Water proof and dust proof, it is rated for exposed exterior locations.
TECHNICAL SPECIFICATIONS
Power Source
Rated Load
Lumens
Colour Temperature
Protection Rating
Mounting
Construction
BEFORE YOU START
Please read all the instructions prior to installation.
The Pukaki Wall Light should be wired to its own light switch.
Do not connect with other lamp types on the same switch.
An earth connection must be used for electrical safety.
For all locations, please check that the direction of the beam will not cause undue glare to neighbouring
properties.
!
IMPORTANT
This product is suitable for use only with a supply voltage of 220-240V AC 50Hz.
All electrical work must be carried out in accordance with local and national electrical codes as applicable.
We strongly recommend that this light fitting is installed by a registered electrician.
Always switch power off prior to installation. A means of mains power isolation must be installed in the circuit
for the purpose of safe access for any internal cleaning, recalibration, or maintenance.
This light fitting is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Young children should be
supervised to ensure that they do not play with the appliance.
Any changes or modifications made or attempted to this product, without the prior written approval of the
manufacturer, will void any and all stated warranties.
220-240V AC Class I
10 Watts
460 Lumens
Warm White 3000K
IP65
Wall
Powder Coated Aluminium,
UV Stabilsed Polycarbonate
WHITE LHT1112
ANTHRACITE LHT1111