Proflex VB100 User Manual page 3

Vibration Platform Machine – VB100
General Electrical Safety
• Inspect electrical equipment, extension
cords, power bars, and electrical fittings for
damage or wear before each use. Repair or
replace damaged equipment immediately.
• Ensure all power sources conform to
equipment voltage requirements and are
disconnected before connecting or
disconnecting equipment.
• When wiring electrically powered
equipment, follow all electrical and safety
codes.
• Wherever possible, use a residual current
device (RCD).
• High voltage / high current power lines may
be present. Use extreme caution to avoid
contact or interference with power lines.
Electrical shock can be fatal.
Basic precautions, including the following important safety instructions should always be followed when using the machine. Read all instructions
before use.
To reduce the risk of electric shock, always unplug the machine from the electrical outlet after use and before cleaning, assembling, or servicing.
Failure to follow these instructions may lead to personal injury and cause damage to the machine.
Before beginning any exercise program, consult your physician. This is especially important for people over 35 years of age or who have pre-
existing health problems. Read all instructions before using any fitness equipment.
WARNING! To reduce the risk of burns, fire, electric shock or injury, read the following:
• Use this product for its intended use only as described in this user manual. Do not use attachments not recommended by the manufacturer.
• Never operate the unit with a damaged cord or plug, or if it is not working properly. If it has been dropped, damaged or exposed to water, have
the unit inspected/repaired by an authorised service centre.
• Caution – To avoid injury, use caution when stepping on to or off the machine.
• Maximum weight capacity = 180kg
• Do not attempt any maintenance or adjustments other than those described in this user manual. Should any problems arise, discontinue use and
consult an authorized service centre or personnel.
• Never operate the appliance with the air openings blocked. Keep the air openings free of lint, hair, and other obstructions.
• Do not use the unit outdoors.
• Do not pull the unit by its power cord or use the cord as a handle.
• Keep children and pets away from the equipment while in use.
• Elderly or disabled users should only use the unit in the presence of an adult who can provide assistance if required.
• Do not operate where aerosol (spray) products are in use or where adequate oxygen is not available.
• Keep dry – do not operate in wet or moist conditions.
• The motor cover can become hot while the unit is in use. Do not place the unit on a flammable surface as this can create a fire hazard.
• Keep electrical cord away from hot surfaces.
• Keep the unit on a solid, level surface with a minimum safety area clearance of two meters around it. Be sure the area around the treadmill
remains clear of any obstructions during use.
• The machine is for domestic household use only.
• Only one person should use the machine at a time.
• Wear comfortable and suitable clothing when using the machine.
• Do not leave children unsupervised near or on the machine.
• Children should not be allowed to play or operate the machine at any time.
• To disconnect, turn all controls to the OFF position, then remove plug from the wall outlet.
• The machine is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• This unit must be plugged into a nominal 240VAC / 50Hz grounded mains electrical outlet.
• Keep hands clear of all moving parts. Never place hands or feet under the machine while in use.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• Allow the machine to stop fully and unplug the power cord from the wall outlet before moving it.
E&OE
General Electrical Safety
• Electrically grounded equipment must have
an approved cord and plug and be
connected to a grounded electrical outlet.
• Do NOT bypass the ON/OFF switch and
operate equipment by connecting and
disconnecting the electrical cord.
• Do NOT use equipment that has exposed
wiring, damaged switches, covers or
guards.
• Do NOT use electrical equipment in wet
conditions or in damp locations.
• Do NOT use electrical cords to lift, move or
carry equipment.
• Do NOT coil or knot electrical cords, and
ensure electrical cords are not trip hazards.
Vibration Platform Safety
© 2020 Proflex
General Service Information
• The equipment must be serviced or
repaired at authorised service centres by
qualified personnel only.
• Replacement parts must be original
equipment manufacturer (OEM) to ensure
equipment safety is maintained.
• Do NOT attempt any maintenance or repair
work not described in this manual.
• After use, the equipment and components
may still be hot – allow the equipment to
cool and disconnect spark plugs and/or
electrical power sources and/or batteries
from it before adjusting, changing
accessories or performing repair or
maintenance.
• Do NOT adjust while the equipment is
running.
• Perform service related activities in suitable
conditions, such as a workshop.
• Replace worn, damaged or missing
warning/safety labels immediately.
3