OWL 4 BOLT Series Quick Reference Manual

OWL 4 BOLT Series Quick Reference Manual

Test kits

Advertisement

Quick Links

Fiber OWL 4 BOLT Series Test Kits
Certification Testing
Quick Reference Guide
For part numbers:
KIT-FO4B-WSSDst
KIT-FO4B-WSSDsc
OWL
Optical Wavelength Laboratories
Quick Reference Guide
Revision 1.1
Optical Wavelength Laboratories (OWL)
Fiber OWL 4 BOLT Series
25909
N9623 West US Hwy 12
Firmware Version 4.65
Whitewater, WI 53190
Phone: 262-473-0643
Internet: OWL-INC.COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4 BOLT Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for OWL 4 BOLT Series

  • Page 1 Fiber OWL 4 BOLT Series Test Kits Certification Testing Quick Reference Guide For part numbers: KIT-FO4B-WSSDst KIT-FO4B-WSSDsc Optical Wavelength Laboratories Quick Reference Guide Revision 1.1 Optical Wavelength Laboratories (OWL) Fiber OWL 4 BOLT Series 25909 N9623 West US Hwy 12 Firmware Version 4.65...
  • Page 2 GETTING STARTED Thank you for your purchase of this OWL certification test kit. Included in this kit is a Fiber OWL 4 BOLT optical power meter and a WaveSource multimode fiber optic light source. This quick reference guide will assist you in setting up your test kit for a standards-based certification test.
  • Page 3 Press <F3> until the Fiber OWL 4 BOLT is set to 1310nm wavelength. STEP 6 The power reading on the Fiber OWL 4 BOLT display should be approximately -10.00 dBm. If the reading is -12.00 dBm or below, it is recommended to replace the cable.
  • Page 4 STEP 9 The power reading on the Fiber OWL 4 BOLT display should be approximately -10.00 dBm. If the reading is -12.00 dBm or below, it is recommended to replace the cable. STEP 10 Once proper operation has been verified, remove the second patch cable from both units and set it aside.
  • Page 5 RUN LINK WIZARD, cont. STEP 22 Connect the Fiber OWL 4 BOLT to your fiber link as shown in Figure 3. CONNECT FIBER A FIBER B (FIBER PAIR REQUIRED) PATCH FIBER A TO Press <F1> to continue. FIBER B AT THE FAR...
  • Page 6 TAKE READINGS STEP 35 If testing two wavelengths, press the <AUTO> button to set the Fiber OWL 4 BOLT into AUTO mode, then press and hold the /AUTO button on the WaveSource. You will begin to see the WaveSource indicator LED...

This manual is also suitable for:

Kit-fo4b-wssdstKit-fo4b-wssdsc

Table of Contents