Table of Contents
Advertisement
Check that the ice maker door is not flush with the
■
standard cabinets to avoid problems with opening the ice
maker door.
F
E
w
H
I
A
Width (For 15" Ice maker)
Width (For 18" Ice maker)
B
Width of outlet location
C
Outlet location – distance from
side
D
Outlet location – distance from
bottom
E
Width of water connection
location
F
Height
G
Height of outlet location
H
Height of water connection
location
I
Depth of cabinet (min.)
e
Recommended electrical connection location
w
Recommended water connection location
Choose a location where the floor is even. It is important for
■
the ice maker to be level in order to work properly. If needed,
you can adjust the height of the ice maker by changing the
height of the leveling legs. See "Leveling."
A
C
B
e
G
D
15" (38.1 cm) Min.
18" (45.7 cm) Min.
6" (15 cm)
1" (2.5 cm)
12" (30.5 cm)
3½" (8.9 cm)
34" (86.4 cm) Min.
34½" (87.6 cm) Max.
8" (20.3 cm)
9" (22.9 cm)
24" (61.0 cm)
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your ice maker into its final location, it is
important to make sure you have the proper electrical connection:
A 115 V, 60 Hz, AC only, 15 or 20 A electrical supply, properly
grounded in accordance with the National Electrical Code and
local codes and ordinances, is required.
It is recommended that a separate circuit, serving only your ice
maker, be provided. Use a receptacle which cannot be turned off
by a switch or pull chain.
IMPORTANT: If this product is connected to a GFCI (Ground
Fault Circuit Interrupter) equipped outlet, nuisance tripping of the
power supply may occur, resulting in loss of cooling. Ice quality
may be affected. If nuisance tripping has occurred, and if the
condition of the ice appears poor, dispose of it.
Recommended Grounding Method
The ice maker must be grounded. The ice maker is equipped with
a power supply cord having a 3 prong grounding plug. The cord
must be plugged into a mating, 3 prong, grounding-type wall
receptacle, grounded in accordance with the National Electrical
Code and local codes and ordinances. If a mating wall receptacle
is not available, it is the personal responsibility of the customer to
have a properly grounded, 3 prong wall receptacle installed by a
qualified electrician.
3
Advertisement
Table of Contents
