Dehumidification Mode; Fan Mode; Auto Operation; Power Cooling - Friedrich C36YJ Owner's Manual

Operating Instructions

Dehumidification mode

Fan Mode

Auto Operation

Power Cooling

You can activate this operation by pressing the SURGE BUTTON.
To change from jet cool mode to high fan speed cooling mode, press the SURGE BUTTON
or INIDOOR FAN SPEED SELECTOR BUTTON or the ROOM TERPERATURE SETTING
BUTTON again.
12 Multi zone
During Healthy Dehumidification Operation
❏ If you select the dehumidification mode on the OPERATION MODE SELECTION
BUTTON, the product starts to run the dehumidification function. It automatically
sets the room temperature and airflow volume to the best condition for
dehumidification, based on the sensed current room temperature.
In this case, however, the setting temperature is not displayed on the remote
ontroller and you are not able to control the room temperature either.
❏ During the healthy dehumidification function, the airflow volume is automatically set
according to the optimization algorithm responding to the current room temperature status,
so that the room condition is kept healthy and comfortable even in the very humid season.
This operation circulates the air without cooling or heating. It can be
activated by pressing the FAN BUTTON. Once the air circulation is
activated you can select the air speed by pressing the INDOOR FAN
SPEED SELECTOR BUTTON.
In this operation mode, the system is automatically operated by the
electronic controls.
- You can set the desired temperature between 64°F and 86°F for Auto
Operation mode.
NOTE
This function properly operates when you use the remote controller
matching each model.
Surge function can be used to cool the room quickly in hot summer. When this
function is turned on, the air conditioner runs in cooling operation mode with super high
fan speed and 18°C(64°F) setting temperature for 30 minutes for fast and effective
cooling.