Table of Contents
Advertisement
OPERATION
1. Establish the proper depth of cut (typically less than 1/16" or 1.6mm), using
either the DRO or scale.
2. Pull out and lock each extension roller to support long stock
3. Start dust collection.
4. Start planer.
5. Adjust feed speed (Fig. 8, C) to desired speed (16 or 28 FPM), while planer is
running.
6. Feed stock into planer, maintain control and support of stock until the stock is
securely feeding through planer.
7. Reposition yourself to the outfeed side of planer and control and support stock
until it has exited the outfeed roller.
MAINTENANCE/ADJUSTMENT
Shear-Tec II Cutterhead
Figure 13: Cutterhead
Knife inserts are dangerously sharp. Use extreme caution when
inspecting, removing, or replacing knife inserts.
20
Advertisement
Table of Contents
