Install Optional Backguard; Install Anti-Tip Bracket - KitchenAid KDRS463VBU Installation Instructions Manual

Install Optional Backguard

All ranges may require a backguard. See "Cabinet Dimensions"
in the "Location Requirements" section. See the "Tools and
Parts" section for information on ordering.
Remove island trim and attach backguard using 6 screws.
Insert 3 from the front and 3 from the back (9" [22.9 cm]
backguard shown).

Install Anti-Tip Bracket

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor, you can use the
wall-mounting method.
2. Determine and mark centerline of the cutout space. The
mounting bracket must be installed on the right side of
the cutout. Position mounting bracket in cutout as shown
in the following illustration.
Measurement B:
30" (76.2 cm) ranges: 14
36" (91.4 cm) ranges: 17
48" (121.9 cm) ranges: 23
/ " (36.1 cm)
1
4
/ " (43.8 cm)
1
4
/ " (59.3 cm)
3
8
Measurement C:
Optional distance from back wall. If back wall is constructed
of a combustible material and a backguard is not installed,
a 6" (15.2 cm) minimum clearance is required for all models.
Install anti-tip bracket accordingly.
A. Centerline
B. Centerline of cutout to outside
edge of anti-tip bracket
C. Back wall to back of range
3. Drill two / " (3.0 mm) holes that correspond to the
1
8
bracket holes of the determined mounting method.
See the following illustrations.
Floor Mounting
B
A
A. #12 x 1
B. Anti-tip bracket
Wall Mounting
B
A
A. #12 x 1
B. Anti-tip bracket
4. Using a Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1
Depending on the thickness of your flooring, longer screws
may be necessary to anchor the bracket to the subfloor.
Longer screws are available from your local hardware store.
5. Move range close enough to opening to allow for electrical
connections to be made. Remove shipping base, cardboard,
or hardboard from under range.
6. Continue installing your range using the following installation
instructions.
A
B
C
⁄ " screws
5
8
⁄ " screws
5
8
/ " screws provided.
5
8
13