Table of Contents
Advertisement
ELECTRICAL CONNECTIONS
CONNECTING ELECTRICAL LOADS
Attempting to connect generator directly to the electrical system of any building structure.
Back feeding electricity through a building's electrical system to the outside utility feed lines could endanger repair persons attempting to restore
service. Failure to use a double throw transfer switch when connecting to a structure's electrical system can damage appliances and WILL VOID
the manufacturer's warranty. Never backfeed electricity through a structure's electrical system. To connect to a structure's electrical system in a
safe manner, always have a Double-Throw Transfer Switch installed by a qualified electrician and in compliance with local ordinances. (When
installing a Double-Throw Transfer Switch, a minimum of 10 gauge wiring must be used).
IMPROPER CONNECTION OF ITEMS TO GENERATOR
Exceeding the load capacity of the generator by attaching too many items, or items with very high load ratings to it could result in overheating of
some items or their attachment wiring resulting in fire or electrical shock. Make sure that the sum total of electrical loads for all attachments does
not exceed the load rating of the generator.
WARNING! Failure to connect and operate equipment in the sequence below can cause damage to equipment and will void the warranty.
1) Let engine run and warm up for five minutes after starting with no electrical load. Connect loads in the following manner:
2) Connect "inductive" load equipment first, inductive loads consist of refrigerators, freezers, water pumps, air conditioners, or small hand tools.
Connect the items that require the most wattage first.
3) Connect the lights next.
4) Voltage sensitive equipment should be the last equipment connected to the generator. Plug voltage sensitive appliances such as TV's, VCR's,
microwaves, ovens, computers, and cordless telephones into a UL/CSA listed voltage surge protector, then connect the UL/CSA listed voltage
surge protector to the generator.
Overloading the generator will cause power fluctuations and can damage equipment and appliances. King Canada will not be
responsible for equipment damaged as a result of voltage surges, improper operation or improper installation of the generator.
CONTROL PANEL
120V AC DUPLEX RECEPTACLE
For normal 120V operation, plug your appliance or power bar into one of the two duplex 120V receptacles (A) Fig.7.
12V DC TERMINALS-Main use, charging automotive batteries
IMPORTANT: Allow generator to run at no load for 5 minutes upon each initial
start-up to allow engine to stabilize.
To charge battery:
1) Using the supplied battery cables, connect the red positive (+) battery clamp to the
battery's positive (+) terminal.
2) Connect the black negative (-) battery clamp to the battery's negative (-) terminal.
3) Connect the red positive wire (+) to the positive (+) terminal (B) on the genrator
panel. Connect the black negative wire (-) to the negative (-) terminal (C) on the
genrator panel.
4) Charge the battery according to battery or equipment manufacturer recommen-
dations.
To operate 12V DC equipment:
1. Refer to the 12V DC equipment owner's manual for operation of equipment and any special cable or adapter requirements.
RESET AND CIRCUIT BREAKER
The control panel contains a 12V DC reset button (D) and a main AC circuit breaker (E). If an overload occurs (reached maximum capacity), the
corresponding reset button or circuit breaker will "trip" to their "Off" position, causing the generator to automatically shut off. Disconnect all
electrical items from the control panel. Position the circuit breaker in the On position and restart the generator. If the reset or circuit breaker
continues to "trip", the electrical item or items are exceeding the amperage capacity of this generator, reduce electrical charge or use a more
powerful generator.
ELECTRICAL CONNECTIONS
Figure 7
Advertisement
Table of Contents
