Power On/Off; Turning On The Power; Turning Off The Power - ViewSonic PJ1172 User Manual

Power On/Off

WARNING
• When the power is "On", a strong light is emitted. Do not look into the lens or vents of
the projector.
NOTE
• Turn the power on/off in right order. Please power on the projector before the connected
devices. Power off the projector after the connected devices.

Turning On The Power

Remove the lens cap.
1
Set the power switch to [ | ] (On).
2
The STANDBY/ON indicator will light to solid
orange.
Press the STANDBY/ON button.
3
The projector lamp will light up and the STANDBY/
ON indicator will begin blinking green. When the
power is completely on, the indicator will stop
blinking and light green.
Select an input signal according to the section
4
"Selecting An Input Signal" of the following page.

Turning Off The Power

Press the STANDBY/ON button.
1
The message "Power off?" will appear on the
screen for approximately 5 seconds.
Press the STANDBY/ON button again while
2
"Power off?" message is visible.
The projector lamp will go off, and the STANDBY/
ON indicator will begin blinking orange. The
STANBY/ON indicator will stop blinking and light to
solid orange when the lamp cooling is complete.
Set the power switch to [O] (Off).
3
The STANDBY/ON indicator will go off.
Attach the lens cap.
4
STANDBY/ON button / indicator
Power switch (On position)
STANDBY/ON button / indicator
Power switch (Off position)
ViewSonic PJ1172
STANDBY/ON
button
STANDBY/ON
button
13