Page 1
MODEL UX-K02 Charge the battery for about hours before initial use. 10 horas Cargue la batería durante aproximadamente antes del primer uso. Introduction Connecting the Cordless Handset Charger Installing and Charging the Battery Registering the Cordless Handset Enterring a Name for the Cordless Handset...
If trouble is experienced with this equipment, or for repair or warranty information, please contact Sharp's Customer Assistance Center. The number is 1-877-794-8675. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.
. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some...
Important safety information Do not disassemble this product or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel. Do not use this product near water, or when you are wet. For example, do not use this product near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.
Connecting the Cordless Handset Charger Connect the AC adapter to the Place the cord in the holders. cordless handset charger. Plug the AC adapter into a standard 120 V AC outlet. Important: Never cover the charger and AC adapter with a blanket, cloth, or other material.
Page 6
Place the cordless handset in the charger with the dial pad facing forward. • Important! The dial pad must face forward, or the battery will not charge. • While charging the first time, the display may show PLEASE REGISTER. Be sure to let the battery charge for 10 Charge the battery hours, and then register the cordless...
Page 7
Registering the Cordless Handset After the initial charging, To use the cordless handset, the cordless handset display shows: you must first register it in the machine. During registration, HANDSET? the machine will assign the handset a number. Fax machine display: INTERCOM/ CONFERENCE On the machine, hold down...
Page 8
The machine is identified by the number “0”, and the cordless handset that was included with the machine is identified by the number “1”. Entering a Name for the Cordless Handset Enter a name for the cordless handset in the machine. ♦...
Page 9
Enter the name by pressing number keys for each letter as shown in the chart below. Up to 10 characters can be entered. Example: BILL = 22 444 555 SPACE = ♦ To enter two letters in succession that require the same key, press after entering the first letter.
If you find that LOW BATTERY appears in the cordless handset display soon after the battery is charged, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3.6 V Ni-MH battery, capacity: 850 mAh) Caution: There is a danger of explosion if the battery is incorrectly replaced.
Page 11
Deleting (changing) the cordless handset name Follow the steps below if you need to delete the cordless handset name. If you wish to change the name, delete it and then enter a new name. Machine display: FUNCTION Press once and twice on ENTRY MODE the machine.
Page 12
Deleting a cordless handset (using the cordless handset) If you wish to stop using a cordless handset, follow the steps below to delete it (cancel the registration in the machine). ♦ A cordless handset should normally be deleted using that cordless handset as explained below.
Page 13
Deleting a cordless handset (using the machine) Use this procedure to delete a cordless handset only when the cordless handset has failed and cannot be used. Fax machine display: INTERCOM/ CONFERENCE On the machine, hold down MODE SELECT 1: HS ENTRY until the display at right appears.
Page 15
. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some...
Page 16
Important safety information Do not disassemble this product or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel. Do not use this product near water, or when you are wet. For example, do not use this product near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.
Page 17
Connecting the Cordless Handset Charger Connect the AC adapter to the Place the cord in the holders. cordless handset charger. Plug the AC adapter into a standard 120 V AC outlet. Important: Never cover the charger and AC adapter with a blanket, cloth, or other material.
Page 18
Place the cordless handset in the charger with the dial pad facing forward. • Important! The dial pad must face forward, or the battery will not charge. • While charging the first time, the display may show PLEASE REGISTER. Be sure to let the battery charge for 10 Charge the battery hours, and then register the cordless...
Page 19
Registering the Cordless Handset After the initial charging, To use the cordless handset, the cordless handset display shows: you must first register it in the machine. During registration, HANDSET? the machine will assign the handset a number. Fax machine display: INTERCOM/ CONFERENCE On the machine, hold down...
Page 20
The machine is identified by the number “0”, and the cordless handset that was included with the machine is identified by the number “1”. Entering a Name for the Cordless Handset Enter a name for the cordless handset in the machine. ♦...
Page 21
Enter the name by pressing number keys for each letter as shown in the chart below. Up to 10 characters can be entered. Example: BILL = 22 444 555 SPACE = ♦ To enter two letters in succession that require the same key, press after entering the first letter.
Page 22
If you find that LOW BATTERY appears in the cordless handset display soon after the battery is charged, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3.6 V Ni-MH battery, capacity: 850 mAh) Caution: There is a danger of explosion if the battery is incorrectly replaced.
Page 23
Deleting (changing) the cordless handset name Follow the steps below if you need to delete the cordless handset name. If you wish to change the name, delete it and then enter a new name. Machine display: FUNCTION Press once and twice on ENTRY MODE the machine.
Page 24
Deleting a cordless handset (using the cordless handset) If you wish to stop using a cordless handset, follow the steps below to delete it (cancel the registration in the machine). ♦ A cordless handset should normally be deleted using that cordless handset as explained below.
Page 25
Deleting a cordless handset (using the machine) Use this procedure to delete a cordless handset only when the cordless handset has failed and cannot be used. Fax machine display: INTERCOM/ CONFERENCE On the machine, hold down MODE SELECT 1: HS ENTRY until the display at right appears.
In no event shall Sharp be liable, or in any way responsible, for any damages or defects in the Product which were caused by repairs or attempted repairs performed by anyone other than an authorized servicer.
Page 28
How Exchange is Obtained A replacement unit in exchange for your fax is provided by Sharp to any U.S. location. You will be required to provide consent for acceptance of an exchange unit and provide credit card authorization. At that time, Sharp will ship to you, at no cost, an exchange for your defective product. The exchange unit we ship to you will be new or remanufactured.
SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 http://www.sharpusa.com SHARP CORPORATION FOR YOUR RECORDS Please record the model number and serial number below, for easy reference, in case of loss or theft. These numbers are located on the rear side of the unit. Space is also provided for other relevant information.