Installing The Stainless Steel Handle; Operating Your Appliance; Control Panel For Ff1532B/Spr316Os/Ff64B/Ff64Bss/Spr627Os - Summit Professional FF1532B Instruction Manual

INSTALLING THE STAINLESS STEEL HANDLE

This appliance includes a stainless steel handle that is not required to
operate the unit. To install the handle, follow the instructions below:
1. Use a screwdriver to remove the screws on the side of door
where the handle is to be installed.
2. Align the handle with the screws removed in step # 1. Tighten the
screws using a Phillips head screwdriver until the handle is both
flush and secured tightly against the door side. (DO NOT over-
tighten as this will cause damage to the stainless steel door
surface.)
It is recommended you install the appliance in a place where the ambient temperature is between 44º and
90ºF (7º to 32ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate. The operating temperature range may not be reached.
CONTROL PANEL for FF1532B / SPR316OS / FF64B / FF64BSS / SPR627OS
ON/OFF Power
To turn the appliance ON or OFF, touch the
NOTE: Pressing the POWER key once can switch off the audible alarm when the alarm is on.
LIGHT
To control the inner light.
UP
Used to increase (warm) the set temperature by 1°C/1ºF.
DOWN
Used to decrease (cool) the set temperature by 1°C/1ºF.
ºF/ºCSelector
Select the temperature display in Fahrenheit or Celsius degrees. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5 seconds.

OPERATING YOUR APPLIANCE

Handle
symbol and hold for 5 seconds.
9
Screw
Door