Installation - AEG S53630CSW2 User Manual

32 www.aeg.com
Problem
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
8.3 Replacing the lamp
1. At the same time, with the fingers
expand up and down the transparent
9. INSTALLATION
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
If the advice does not lead
to the desired result, call the
nearest brand-mark service.
The appliance is equipped
with a longlife LED interior
light.
CAUTION!
Disconnect the plug from
the mains socket.
WARNING!
Refer to Safety chapters.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
Possible cause
There is no cold air circula-
tion in the appliance.
cover and unhook it in the direction
of the arrows.
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light comes on.
Climate
class
T
Solution
Make sure that there is cold air
circulation in the appliance.
1
2
1
Ambient temperature
+16°C to + 43°C
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Service Centre