Ricoh FT5034 Service Manual page 83

11. Assemble the pawl shaft assembly and
place it into the cleaning unit, sliding the
rear end of shaft into the hole in the rear
side plate.
NOTE: 1. When installing the cam holder
and the cam rider, align [A] with
[B] as shown in the figure.
2. Make sure that the spring end is
in the small hole on the rear
side plate.
12. Install the pawl shaft pin.
13. Push the spring collar to the rear and rotate
it one turn as shown in the figure.
Then set the collar on the pin.
NOTE: Make sure that the end of the
spring is correctly positioned in the
groove of the collar.
14. Reassemble the cleaning unit.
Cam Rider
Cam Holder
- 82 -
Pawl Shaft Pin
Spring End
Spring Collar
Pin