Table of Contents
Advertisement
Action
Remarks
Image Density too Low
Yes
Detect Supply
Mode 30%?
No
Mark on the toner supply
Clutch Shaft.
Set SP mode (30) to "10".
Turn on DIP SW 101-2 on the
Make the following DIP SW
main board
settings.
101-3: "ON", 101-4: "OFF"
Press the Start key
Yes
2.6 revolutions per
copy
Turn on DIP SW 101-2 on the main
No
board
Set SP mode (88) to "11"
Check the toner supply
clutch
Enter "10"
Press the Start Key
Check the voltage displayed in the
size magnification counter
No
Is V
4.0 ± 0.2
SG
Yes
Adjust VR101 on the main
board while V
is being
SG
displayed
1
- 135 -
Advertisement
Chapters
Table of Contents
