Table of Contents
Advertisement
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the appliance is exposed to the
sun or to heat, remove the film after the appliance cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a dispenser unit or ice storage bin. The ice storage
bins listed below are recommended.
Model Number Bin Width
KM-1100M_H
KM-1340M_H
KM-1601MRH/3
For further options, contact your local Hoshizaki distributor.
• NOTICE! Remote models must be connected to an appropriate remote condenser
unit. The remote condenser units listed below are recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specific application. For further
details, contact your local Hoshizaki distributor.
Model Number Recommended Hoshizaki Remote Condenser Unit
KM-1100MRH
URC-14F
KM-1340MRH
KM-1601MRH/3 URC-22F
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
pull towards you.
• Top Panel: Lift up at front slightly, push
rearward and lift off.
• Right Side Panel: Remove the screw. Slide
forward slightly and lift off.
• Insulation Panel: Lift up slightly, and pull
towards you.
Recommended Hoshizaki Ice Storage Bin
30" or Wider B-500 Series
Insulation Panel
Front
Panel
13
Top Panel
Right
Side
Panel
Fig. 1
Advertisement
Table of Contents
