Icemaker - Hoshizaki KM-1100MAH Instruction Manual

1. Icemaker

Icemaker Water Minimum Icemaker
Supply Inlet Water Supply Line Size
1/2" Female Pipe 3/8" Nominal ID
Thread (FPT) Copper Water Tubing or
Equivalent
• An icemaker water supply line shut-off valve and drain valve must be installed.
• Be sure there is sufficient extra water supply line and drain line for the appliance to be
pulled out for service.
Icemaker Water Supply Inlet
1/2" FPT
Remote Condenser
Line Set Connections
Icemaker
Drain Outlet
3/4" FPT
Icemaker
Condensation
Drain Outlet
3/8" OD Hard
Tube
Bin Drain Outlet
3/4" FPT
Fig. 5 Air-Cooled and Remote Models
Model Shown:
KM-1601MRH
Icemaker Drain
Outlet
3/4" Female Pipe
Thread (FPT)
Minimum 3/8" Nominal ID Copper
Water Tubing or Equivalent
Icemaker
Ice
Storage
Bin
Minimum 3/4" Nominal ID
Hard Pipe or Equivalent
19
Minimum Icemaker
Drain Line Size
3/4" Nominal
ID Hard Pipe or
Equivalent
Shut-Off Valve
Drain Valve
Be sure there is sufficient
Vent Tube extra water supply line and
drain line for the appliance
to be pulled out for service.
Separate piping to approved
drain. Leave a 2-inch (5-cm)
vertical air gap between the
end of each pipe and the
drain.
2-inch (5-cm) air gap
Condensation
Drain Outlet
3/8" OD Hard
Tube
Floor Drain