How To Remove Panels - Hoshizaki F-801MAJ Instruction Manual

• Remove the protective plastic film from the panels. If the appliance is exposed to the
sun or to heat, remove the film after the appliance cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• Flaker models can be installed on an ice storage bin only. Cubelet models can be
installed on either a dispenser unit or an ice storage bin. The ice storage bins listed
below are recommended.
Model Number
F-450MAJ(-C)
F-801M_J(-C)
F-1002M_J(-C)
FD-650M_H-C
FD-1002M_J-C
F-1501M_J(-C)
For further options, contact your local Hoshizaki distributor.
• NOTICE! Remote models must be connected to an appropriate remote condenser
unit. The remote condenser units listed below are recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specific application. For further
details, contact your local Hoshizaki distributor.
Model Number
F-1002MRJ
F-1002MRJ-C
FD-650MRH-C
FD-1002MRJ-C
F-1501MRJ(-C)
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
towards you.
• Top Panel: Lift up at front slightly, push rearward
and lift off.
• Side Panels: Remove the screw. Slide forward
slightly and lift off.
Bin Width Recommended Hoshizaki Ice Storage Bin
22" or Wider B-300 Series
BD-300 Series
30" or Wider B-500 Series
Recommended Hoshizaki Remote Condenser Unit
URC-5F
URC-14F
Side Panel
Front Panel
Model Shown: FD-650MAH-C
17
Top Panel
Side Panel
Fig. 1