Table of Contents
Advertisement
Option Selections
To Start a Cycle
When the cycle and options have been selected,
the LEDs over the cycle and options selected will
illuminate. The status window will display the cycle
time and then displays "Press START".
To start the cycle, press START/CANCEL pad and
close the door immediately.
The status window displays "Close Door" after the
START/CANCEL pad is pressed.
A tone will sound indicating the cycle has
successfully started after the door is closed.
Sanitize
To sanitize your dishes and glassware, select
SANITIZE option, by pressing SANITIZE pad.
When selected, the light will come on and remain
on after the cycle has completed. The water
temperature in the fi nal rinse will be raised to 155
(68
o
C) and will maintain that temperature for 9
minutes. This option is available in Power Plus and
Normal Wash Cycles. Only these sanitization cycles
have been designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120
o
F (49
o
C).
The sanitize criteria may not be satisfi ed if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120
Sanitize pad fl ashes at the end of the cycle if the
NSF requirements for sanitization are not reached.
To turn off the SANITIZE option, press the
SANITIZE pad. The SANITIZE light will turn off.
High
HIGH option is selected, by pressing the HIGH
pad. The dishwasher heats water in the main
wash to approximately 140
the temperature higher in the fi nal rinse to help
with the drying stage.
This helps dishwasher detergent remove food
grease and soil from dishes more effectively and
aids in drying performance by adding additional
rinse aid and increasing the water temperature.
OPERATING INSTRUCTIONS
o
F (49
o
C).
o
F (60
o
C) and increases
My Favorite Cycle
The MY FAVORITE CYCLE option allows you to
program your preferred cycle and options into one
button. Once Programmed, simply press the MY
FAVORITE CYCLE button followed by the START/
CANCEL pad will select the programmed cycle and
options.
To Program the MY FAVORITE CYCLE button:
1.
Select your preferred cycle and options
2.
Hold the MY FAVORITE CYCLE button for 3
seconds.
The LED over the MY FAVORITE pad turns on
indicating the MY FAVORITE CYCLE option has
been programmed. To change the MY FAVORITE
CYCLE option simply repeat steps one and two
above.
Delay Start
o
F
The DELAY START option allows you to
automatically delay starting your dishwasher from
1-24 hours.
Select your desired cycle and options, then press
the DELAY TIME pad until the desired delay time
displays in the status window. The LEDs of the
selected cycle and options are illuminated. The
status window displays the delay time and then
displays 'Press Start'.
To start the delay countdown, press START/
CANCEL pad and close door immediately.
The status window displays 'Close door' after the
START/CANCEL pad is pressed.
A tone will sound indicating that countdown has
started after the door is closed. The selected cycle
starts when the countdown is completed.
Air Dry
The AIR DRY option uses reduced temperature in
the fi nal rinse. While saving energy and time, you
may have items in your dish load that will not be
completely dry at the end of the cycle. Deselecting
AIR DRY option in combination with rinse aid will
enhance drying performance. AIR DRY option is
not available on all cycles.
5
Advertisement
Table of Contents
