Care And Cleaning - Technibel MCA27C Operating Instructions Manual

2. WHEN THE AIR CONDITIONER IS RUNNIG
If you want to turn off the air conditioner, switch the OPERATION
SELECTOR to the OFF position.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the power
is resumed, the unit will restart automatically after 3 minutes.
EG

CARE AND CLEANING

WARNING
For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will damage
the internal components and cause an electric shock hazard.
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild
liquid detergent.
When cleaning the grille, be careful not to force the vanes out of
place.
The air intake grille can be removed in order to wash it
with water.
Removing and remounting the air intake grille
• With the air intake grille open all the way, grip both
arms with your hans and pull toward you to remove.
• To remount, hold the air intake grille roughly horizontal
and push it in until the arm shafts fit into the indenta-
tions in the main unit, then fit the grille into place.
Washing the grille with water
• Clean the grille gently using a soft sponge, or the like.
Then wipe away any remaining moisture.
• Neutral detergent may be used to remove stubborn
dirt. Then rinse thoroughly with water and wipe away
any remaining moisture.
Never use solvents, or harsh chemicals when cleaning the indoor
unit. Do not wipe the plastic casing using very hot water.
Some metal edges and the vanes are sharp and may cause
injury if handled improperly; be especially careful when you
clean these parts.
The internal coil and other components of the outdoor unit must
be cleaned every year. Consult your dealer or service centre.
AIR FILTER
The filter behind the air intake grille should be checked and cleaned
at least once every two weeks.
Operation
HOW TO REMOVE THE FILTER
selector
Air intake grille
1. Grasp both ends of the air intake grille and pull it towards you
and up.
2. Push the filter up slightly, and then pull it down.
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is sticky dust
on the filter, wash the filter in lukewarm, soap water, rinse it in
clean water, and dry it.
HOW TO REPLACE THE FILTER
Arm
Air intake grille
1. With the «FRONT» mark facing you, slide the filter up
into the unit and then lower the handler into the groove
on the unit.
2. After installing the filter, press the locations marked by
the arrows ( ) and close the air intake grille.
10
CAUTION
Insert into the groove on the unit
Air filter
Air intake grille
Air filter